Skip to content
Made in France since 1948 · Vire, Normandy +33 (0)2 31 66 44 00
Guy Degrenne Industrie Request a quote
Guide · Engineering office · 2 min read

Designing a piece for slip casting: the design rules

A shape that looks good on screen is not always easy to cast. A few design rules, applied from the start, avoid back-and-forth and make series production more consistent.

Designing a piece for slip casting: the design rules

Even wall thickness

In drain casting, the wall forms by itself with an even thickness. Avoid very thick areas next to thin ones: they dry and fire differently and crack.

Draft and undercuts

The piece must be able to come out of the mould. An undercut, a relief that catches, needs an extra mould part: it is possible, but it complicates the mould and leaves a seam line.

Radii rather than sharp corners

A sharp inside corner concentrates stress during drying and firing. A small radius reduces the risk of cracking and makes release easier.

Shrinkage

Porcelain shrinks markedly between the mould and the kiln exit. The model is scaled up accordingly, and dimensions that must fit, a lid or a stopper, are approved on a prototype.

Large flat areas

A wide, flat base can sag during firing. A foot ring, a slight camber or a rib helps the piece keep its shape.

Closed shapes

A closed shape, a figurine or a piggy bank, needs an opening to drain the slip and let air escape during firing.

Handles, spouts and relief

Handles and spouts are often cast separately then attached. Fine relief and text must be deep enough not to be drowned by the glaze.

Do I need a 3D file to start?

It is the simplest way, but a dimensioned drawing or a reference piece is enough to start: the model is then made from them.

Can the design office adapt my design?

Yes: it suggests the adjustments casting needs while keeping the design intent, and approves them with you on a prototype.

The foot

In the kiln, the piece rests on an unglazed area, often the foot. Plan it from the design stage.

Request a quote