Skip to content
Made in France since 1948 · Vire, Normandy +33 (0)2 31 66 44 00
Guy Degrenne Industrie Request a quote
Guide · Engineering office · 2 min read

Launching a slip-cast porcelain shape: from drawing to production mould

Between a drawing and the first production piece come a model, moulds and prototypes. Here are the steps, and what makes a new slip-cast porcelain shape succeed.

Launching a slip-cast porcelain shape: from drawing to production mould

The drawing and the 3D file

Everything starts with a dimensioned drawing or a 3D file. Our design office checks that the shape casts well: thicknesses, draft angles, undercuts, fragile areas, position of handles and spouts.

The model

The model is the reference piece, sculpted by hand or 3D printed. It is enlarged to compensate for the shrinkage of porcelain, which contracts significantly during drying and firing.

The master mould and production moulds

A master mould is taken from the model and used to make the plaster production moulds. These moulds absorb water from the slip; they wear with each casting and are renewed regularly from the master mould.

Prototypes

The first cast pieces are dried, fired and decorated as in production. Dimensions, weight, behaviour in firing, appearance and decoration are checked, then adjusted where needed.

Approval

Once approved, the prototypes become the reference pieces for production: shape, colour and decoration are compared with these samples throughout the run.

Start-up costs

The model, the moulds and the development of the decoration make up the development costs of a shape. They are set out in the quote and amortised over production volumes.

The schedule

Lead time depends on the complexity of the shape and the decoration. Our design office gives you a precise, step-by-step schedule with the quote.

How much does a mould cost?

The cost depends on the complexity of the shape and the number of mould parts. It is quoted separately from the price of the pieces.

Can the shape be changed once the mould is made?

Even a small change may require a new model and new moulds. It is best to approve the shape on a prototype before launching the tooling.

Information for a quote

Send the drawing or 3D file, the dimensions, the material required, the colour or decoration, the annual volumes and the target launch date.

Request a quote