Skip to content
Made in France since 1948 · Vire, Normandy +33 (0)2 31 66 44 00
Guy Degrenne Industrie Request a quote
Guide · Engineering office · 2 min read

Designing a mug: capacity, handle, rim and balance

A good mug shows in the hand: it is balanced, the handle takes your fingers without getting hot, the rim is gentle on the lips. These qualities are designed before the first model.

Designing a mug: capacity, handle, rim and balance

Capacity

Brim-full capacity differs from usable capacity, a few millimetres below the rim. The design starts from the drink served: tea, filter coffee, latte.

The handle

The handle should fit two or three fingers, stay away from the hot wall and sit high enough to balance the full mug. It is cast separately then attached.

The rim

A slightly thinned rim is pleasant on the lips; too thin a rim chips. Thickness is chosen for the use, domestic or professional.

Base and weight

A wide enough base and well-distributed weight keep the mug from tipping. Porcelain allows thin walls for a light yet strong mug.

Shape and decoration

A straight wall takes an all-round decal easily; a conical or curved shape needs a suitable decoration. Relief is planned in the mould.

What capacity for a mug?

Often between 250 and 350 ml brim-full. It is chosen according to the drink and use, then checked on a prototype.

Can the logo go on the handle?

The handle is narrow and curved: a small relief built into the mould works better there than a decal.

From drawing to prototype

A 3D file, then a printed or cast prototype, let you check how it feels before launching the moulds.

Request a quote