Skip to content
Made in France since 1948 · Vire, Normandy +33 (0)2 31 66 44 00
Guy Degrenne Industrie Request a quote
Guide · Engineering office · 2 min read

Calculating the blank and the drawing ratio of a stainless steel part

Before designing the tool, you need to know which blank to cut and in how many draws to form it. Two notions guide the calculation: the blank diameter and the drawing ratio.

Calculating the blank and the drawing ratio of a stainless steel part

The blank

The blank is the flat piece of sheet that will become the part. In deep drawing, thickness changes little: the blank is estimated by keeping the surface area of the finished part.

A cylindrical cup

For a cup of diameter d and height h, ignoring the radii, the blank diameter is approximately D = √(d² + 4·d·h). A margin is then added for trimming.

The drawing ratio

It is the ratio between the blank diameter and the punch diameter. Beyond a limit value, specific to the grade, the thickness and the tool radii, the sheet tears.

Several draws

A deep part is made in several draws, each with a lower ratio than the one before. 18/10 stainless steel work-hardens as it deforms: annealing between two draws restores its ductility.

Non-cylindrical shapes

For a rectangular, oval or complex-edged part, hand calculation is no longer enough: numerical simulation determines the blank shape and checks each draw.

At Vire

Our engineering office calculates the blank, simulates the drawing draw by draw and designs the tooling made in our Vire workshops.

Can the blank for a non-cylindrical part be calculated?

Yes, by surface calculation or simulation; it is then adjusted during tool trials.

Why allow extra length?

For final trimming: the edge of a drawn part is never perfectly even.

Information for a quote

Send the drawing or 3D file, the grade, the thickness, the tolerances and annual volumes.

Request a quote