Porcelain quality control: defects, tolerances and sampling
A porcelain collection is judged piece by piece. Agreeing with your manufacturer on what is accepted and what is not is the best guarantee of a successful run.
Surface defects
Pinholes and bubbles in the glaze, specks, black spots, runs, areas of glaze too thin or too thick: they show under raking light and are judged by size and position.
Shape
A plate must sit flat, a cup stand straight, a lid fit. Porcelain distorts slightly in firing: flatness and dimensional tolerances are set according to the piece.
Cracks and chips
A crack or chip, however small, is rejected. Checking by sound, a sound piece rings clear, and by eye detects them.
Shade and decoration
Whiteness, body or glaze colour, decoration position and sharpness, decal colours, regularity of the gold line: each criterion is compared with approved reference pieces.
Reference pieces
Approved prototypes become the references for the run. Where needed, limit samples are added to show the maximum accepted defect: everyone judges on the same basis.
Sampling
In series, inspection combines visual sorting in production and sampling inspection at dispatch or receipt, according to standardised plans, known as AQL, with a level of requirement for each type of defect.
At our factories
Our Limoges and Alföld factories inspect each piece at several stages, from forming to decoration. Appearance criteria are defined with you before production.
What is an AQL level?
An acceptable quality limit: it sets how many pieces to inspect in a lot and how many defects are tolerated.
Who inspects on receipt?
The customer or an agency it appoints, according to the agreed sampling plan.
Information to get started
Tell us the use of the pieces, your appearance criteria, the level of inspection you want and, if you have them, your current inspection sheets.